Instructions
All our molds come packaged with priming, filling, and firing instructions. If you have lost your instructions or you just want to check out our instructions before you buy, you are in the right place.
If you have purchased one of our Lidded Box Molds, here are the instructions we include.
If you have purchased a set of our Serpentine Fomers, you can find those instructions here.
Instructions for the Glasslinks products can be found here.
The Smaller Molds tiles, animals, dragonflies, butterflies, shells, snowflakes, jewelry designs, and color blenders are packaged in a plastic bag with a cardstock hangtag. The instructions are located on the inside of the hangtag. If the instructions have been lost, you can find a copy here.
If you have purchased any of the Lighting Panel Formers or the Lighting Hardware, you can find instructions for the 10 Oval here and the 5 Round here.
In our Project Ideas section, we have some special hints for:
- Assorted Small Leaves
- Branches
- Pine Cones and Needles
If you are looking for additional information for the:
- Leaves (3)
- Oak Leaves and Acorns
- Lily Pad and Frog
- Maple Leaves
- Tropical Leaves
- Honey Bees
- Blossoms
- Flowers
Large molds like our plates, fusers, and slump forms are packaged in a box. The instructions for use are printed on card placed inside the box. If the instructions have been lost, you can find a copy for the fusers here and for the large floral forms here.
Again, dont fail to visit Project Ideas portion of our site. It is chock-a-block full of information.
